Dyneema Kit

KIT Balls for sandow assembly with dyneema to make your own loops and loop binding dyneema, as well as sandows ligature wire.

– Application:Custom assembly of sandows Stéphane DUDON´s advice:- Cut 15 cm of red dyneema Denty spearfishing DG5020R.

– Burn both ends and tie a knot at the ends to connect them.

Thread the ball from the top to press it with the knots.

– Slide it all into the Denty Spearfishing TMS sandows mounting T – Tips:Pass a wire through the loop and wrap it around the handle to prevent the ball from falling.

Push the ball and wire into the sandows with the T.

– Tricks slip a screwdriver into the loop so that when tightening, the loop does not enter Completely in the sandows.

Make a constrictor knot with the 15LP15N ligature wires that you squeeze with all your strength with the black thread.

Tips:To tighten harder make two loops at the end of the wire to slide two screwdrivers to have more grip to tighten.

Cut the constrictor wire and burn the ends.

Pull the loop to the bottom so that the ball comes to press with the constrictor.

Make a link node between the two loops with the pure yellow dyneema 10DYP15J or 10DYP20R.

100% Made in EUROPE.